Fits New Chevy 305 350 454 Mini Racing Starter SDR0086 12572716 12583114

Description: Starter Style: MiniStarter Finish: NaturalAdjustable Mounting Block: NoStarter Rotation: StandardMaximum Recommended Compression Ratio: 10.0:1Gear Reduction Ratio: 4.40:1Mounting Block Material: Cast aluminumStarter Mounting Pattern: StaggeredFlywheel/Flexplate: 168-tooth Please verify that this is the right part number you need before ordering. 1993-2004 Chevrolet C3500 5.7L V81993-2004 Chevrolet Corvette 5.7L V82004 Pontiac GTO 5.7L V82002 Chevrolet Silverado 2500 5.7L V82000-2002 Chevrolet Sonora 5.7L V81996-2002 Pontiac Firebird 5.7L V81995-2000 Chevrolet Camaro 5.7L V82000 Chevrolet Express 1500 5.7L V81999-2000 Chevrolet Express 3500 5.7L V81997-1999 Chevrolet Cargo Van 5.7L V81995-1999 Chevrolet Suburban 1500 5.7L V81995-1998 Chevrolet P30 5.7L V81996-1998 Chevrolet R25 5.7L V81997 Chevrolet C35 5.7L V81996-1997 Chevrolet Silverado 5.7L V81997 Chevrolet Suburban 1500 5.7L V81993-1996 Buick Roadmaster 5.7L V81993-1996 Cadillac Commercial Chassis 5.7L V81993-1996 Chevrolet G30 5.7L V81994-1996 Chevrolet Impala 5.7L V81993-1996 GMC G3500 5.7L V81995 Cadillac Fleetwood 5.7L V81994-1995 Chevrolet C2500 Suburban 5.7L V81993-1995 Chevrolet C3500HD 5.7L V81993-1995 GMC P3500 5.7L V8 Starter (engine): A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engines operation under its own power. Starters can be electric, pneumatic, or hydraulic. In the case of very large engines, the starter can even be another internal-combustion engine. Internal combustion engines are feedback systems, which, once started, rely on the inertia from each cycle to initiate the next cycle. In a four-stroke engine, the third stroke releases energy from the fuel, powering the fourth (exhaust) stroke and also the first two (intake, compression) strokes of the next cycle, as well as powering the engines external load. To start the first cycle at the beginning of any particular session, the first two strokes must be powered in some other way than from the engine itself. The starter motor is used for this purpose and it is not required once the engine starts running and its feedback loop becomes self-sustaining. Fault check:The starter often has failures and phenomena that cannot rotate or rotate slowly. In this case, check the following aspects: 1. The battery has no electricity or the electricity is weak, so the starter cannot rotate or rotate slowly. 2. The starter thread is loose or off, and the switch or adsorption switch fails. 3. The brush is worn out or the brush surface is not correct, and the spring is weak, resulting in poor contact of the rectifier. 4. Excitation coil or armature coil is short-circuited or disconnected. 5. The rectifier is fouled and the mica sheet is protruding, causing poor contact between the brush and the rectifier.Organization maintenance In the process of starting the engine, the starter must draw in 344~400Ah from the battery. Therefore, in order to prevent the battery from over-current or damage, the starting time should not exceed 5s. In winter, it is easy to start difficult to start. Multiple starting times should not be too long, and appropriate intervals should be left in each starting. How to Install a Car Starter: There’s never a convenient time for your vehicle’s starter to fail. A car starters job is to kick over the engine in your car so your vehicle starts.When you find yourself with a vehicle that won’t start, there are a number of a number of issues that may be the culprit,but once you’ve narrowed it down to a faulty starter, you can replace it using just common hand tools. Part 1: Removing a Bad Starter (1).Disconnect the battery. You will not need to remove the positive cable on the battery.Always disconnect the battery before servicing the electrical system in your vehicle. (2).Jack up the vehicle if need be. Ensure you jack the vehicle up on firm, level ground. (3).Locate the starter.The smaller cylinder attached to the starter is the starter solenoid.A wire should run directly from the positive terminal on the battery or from the fuse box under the hood to the top terminal on the starter solenoid. (4).Disconnect the wiring to the solenoid. In some cases, it may just be clips you need to disconnect for the wiring.On some starters, you will need to loosen bolts or screws that hold the wires in place. (5).Remove the starter retaining bolts then the starter.Be sure to use the correct size socket, otherwise you risk damaging the bolts. (6).Compare the new starter to the old one. Slide the starter into place. If the two starters don’t look mostly identical, it may not be the correct starter for your vehicle.New starter solenoids often come with four terminals, but can be used with only two. Part 2: Installing a New Starter (7).Insert the starter retainer bolts. If the bolt does not thread properly, unscrew it and try again.Make sure the bolts are tight so they can’t vibrate loose while the engine is running. (8).Connect the wiring to the starter solenoid. With the starter secured in place, reconnect the wiring you disconnected from the old starter onto the terminals on the new one. If your new solenoid has four terminals but your old one had two, only utilize the top and bottom terminal on the new solenoid. If your old one had four and the new one does as well, connect them to the same terminals they were connected to on the old one. (9).Reconnect the battery. With the starter installed and wired, reconnect the black cable to the negative terminal on the battery and tighten it in place. Insert the key into the ignition and attempt to start the vehicle.If the vehicle fails to start with the new starter in place, ensure the battery is fully charged. (10).Listen to the vehicle as you attempt to start it. As you turn the key in the ignition, listen for the sounds the engine makes to help determine if you have an issue with your starter. If the engine makes no sound whatsoever, or you hear only a faint clicking, it may be because there isn’t enough power reaching the electric starter motor. (11).Ensure the battery terminals are clean and secure.Charge your vehicle’s battery. A weak connection from the battery can prevent the engine from starting.Wear gloves when cleaning battery terminals to avoid getting battery acid on your skin. If you suspect the battery may simply be low on power, try charging it using either a trickle charger or another vehicle to jump start it. Be sure to connect the red cable to the positive terminal on each vehicle and the black to the negative. (12).Check to see the starter solenoid is bad. If the test light does not light up, it means power is not reaching the starter motor due to a faulty solenoid or a dead battery.If the test light does light up, it means the solenoid is good, but the starter itself may have failed. Frequently Asked Questions: (1).Why is my car starter burning out?You likely cranked the starter for too long. (2).I have to change the starter fairly often in my car. What could be causing this?A leak of some sot could be fouling the starter if fluid is dripping on it. If thats the case, replacing the starter doesnt fix the leak so its only a matter of time before the new starter fails. (3).What is the black wire connected to?He black wire can be commonly associated with the wire that connects the battery to the ignition. If this is not the wire that you are referring to then it could be a random wire that has been detached from your fuse box? How big is this wire? If it is rather stout then that would be your battery cables. If it is a small wire then it could be several different things. Follow it and find the origin of the wire, it could be a simple fix just take a look at it. (4).What does a bad starter sound like?In my case, there was very little noise when the ignition was turned, and all that was heard was a distinctive click. One really common sign is if you see any smoke coming from the starter. (5).If my car is grinding when I turn the key, does that mean I have a bad starter?No. Its your flywheel. When you start your car the grinding noise would be your flywheel thats connected to the starter. (6)What causes a starter to go bad?CAUSES OF FAULTY STARTERS: CAUSE OF FAILUREElectrical connections faulty. Solenoid switch (engaging relay) stiff or faulty. Electric motor damaged electrically. Single-pinion gear, starter pinion or freewheel damaged. WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. 1.We only accept PayPal. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 10 days as auction ended or order might be delayed. 1.We only accept PayPal. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 10 days as auction ended or order might be delayed.1.We only accept PayPal. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 10 days as auction ended or order might be delayed. 1. Orders processed within 24 hours of payment verification. 2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address. 3. The images shown are not the actual item and are for your reference only. 4. Fast shipping:All our packages use USPS First Class/UPS/Fedex.... Package Service 5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction! 1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS! 2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable. 3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer. We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns. Copyright of Top-liftsupport. All rights reserved.

Price: 52.99 USD

Location: Ontario, California

End Time: 2023-11-19T17:31:54.000Z

Shipping Cost: 0 USD