Black Holder for Ryobi USB Lithium Multi-Head Screwdriver Set &Case FVD51K

Description: Holder for Ryobi USB Lithium Multi-Head Screwdriver Set and Case FVD51K | Does NOT include Screwdriver set | Garage or Shop Organization Color =Black This holds one case for the Ryobi USB Lithium (4V) Multi-Head Screwdriver Set (FVD51K) securely in a vertical orientation on it's side. The bottom holds the base of the case precisely and the diagonals on the sides fit snugly to keep the case from leaning. The back is designed to be mounted in a variety of ways including screws to the wall, pegboard*, and Ryobi Link Wall Rails. It does NOT include the Ryobi Multi-Head Screwdriver and is shown in photos for reference only. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw to hold it into place. * Note that there are many different types of pegboard and some may not work. This was designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. The holder's dimensions are 8.7" x 5.6" x 2.9" (220mm x 141 mm x 74mm). It is designed to hold the case for the Ryobi USB Lithium Multi-Head Screwdriver Set only and it's dimensions are 7.7" x 7.8" x 2.6" (196mm x 198mm x 65mm). It has not been designed for cases other than for the FVD51K set. These are uniquely designed and 3D-printed by the Seller in the USA. There is no warranty and are sold as-is. Items are lightweight and made of PLA plastic thus we cannot warrant that deformations or failure may occur due to extreme temperatures, stress, or weight. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic. Please see my other listings for additional items and designs.

Price: 15.95 USD

Location: Lexington, Kentucky

End Time: 2024-11-27T23:46:09.000Z

Shipping Cost: 0 USD